MeArm Maker Technical Details

This document is relevant only for the following hardware:

  • mearm-v3

The MeArm Maker requires a separate control board, such as an Ardunio or Raspberry Pi, that can provide a PWM Signal to control the servos

Power at 5-6V and around 2-3A needs to be supplied to the servo motors via the 5+ (red) pin. With Ground from the power supply attached to GND. The remaining pins control the servo motors and require a PWN output from a microcontroller. The PWN signal generator needs to be connected to the GND of the power supply to provide the correct reference voltage.

The pinout of the 6 pin connector is:

Pinout

This article is a stub and we will add more detail in future.