This document is relevant only for the following hardware:
If your MeArm pack contains elastic bands, then these are the instructions for you. If it does not contain elastic bands, check out the MeArm V1 or MeArm V3 instructions.
This video shows the whole build process.
You might need to calibrate your servo motors before building the MeArm. This technique and other specific set up instructions can be found in the following tutorials:
Don’t overtighten the screws! Tightening them too much can damage the arm. The best way of tightening the screws is to screw them in until they stop the joint moving freely and then loosen them slightly until it moves with no friction.
Don’t force any of the pieces into position. If something won’t fit then it’s probably not meant to. If a part is meant to go on a specific way around then it has been designed to only go on that way around. If it doesn’t seem to fit correctly then try turning it around.
You can also view these instructions as a pdf.
